Thursday, September 24, 2009

No Warps to Weave in Bracelet




The beads were attached to the top bar by threading the required number of beads, and then wrapping around that thread and the bar in between each bead so that the strung beads are attached to the top warp bar. Do this for the bottom warpar. Thread warp through a top bead, a bottom bead, top bead, etc. until you have the required number of warps. Begin weaving just above first row of beads on bottom warp bar.





This is the finished piece. In order to remove it, jst cut the thread that is wrapped around the two warp bars. Your will hve two warp ends to weave back in. Notice that you have to place the two warp bars exactly the distance you want the length of your piece to be.














3 comments:

  1. Thank you for this, very eager to try however there are no pictures.

    ReplyDelete
  2. I think I understand the method, but having the photos would be helpful.

    ReplyDelete
  3. OHHH! Thanks for the photos.

    ReplyDelete